How to operate the can beverage production line normally?

How to operate the can beverage production line normally? These problems have become the more important common sense in the use of can beverage production lines. Through this article, we will understand the causes and troubleshooting methods of can beverage production lines.

Fault phenomenon: After booting, the LCD screen of the display controller has no display. Causes of failure: whether the power socket has electricity; whether the power plug is off; the fuse is loose or blown. Troubleshooting: re-insert the plug; reinstall or replace the fuse; note that the fuse must be selected according to the requirements in the specification. NOTE: Be sure to check and determine what caused the blown fuse.

Fault phenomenon: After the machine is turned on, the display screen shows correctly and indicates that it is running, but the pump wheel does not rotate. Causes of failure: The roller in the pump head is stuck; the no-bottle filling stop line is not connected or the level is wrong; the drive circuit board is broken. Troubleshooting: Install the pump head as required; connect the no-bottle stopper line and make it the correct level; check the circuit board for problems. Remarks: The repair of the circuit board, it is best to be repaired by the supplier or company.

Fault phenomenon: The pump wheel rotates, but the liquid cannot be conveyed. Cause of failure: The hose is not pressed in place; the hose is damaged and leaks. Troubleshooting: Adjust the adjusting screw on the pump head cover; replace with a new hose.

Fault phenomenon: The hose slides to one side along with the roller when working. Cause of failure: The hose is not fixed. Troubleshooting: Connect the hose with a tee and hang it on the fixing screw or clamp it with a pipe clamp.